Anhui Beiang Protective Equipment Co., Ltd

Anhui Beiang Protective Equipment Co., Ltd

Safety Helmet Compliance: Essential Wearing Standards for Workplace Protection

2026 05/09

Anhui Beiang Protective Equipment Co., Ltd. emphasizes that even high-quality safety helmets require proper use to deliver full protection. Here are key standards for compliant wear:
 
Before use, adjust the headband for a snug fit, securing the chin strap. Maintain a 25–50mm vertical gap (minimum 32mm) between the head and helmet shell to ensure impact cushioning and ventilation. Never wear the helmet backwards or tilt it back, as this compromises impact resistance. Fasten the chin strap under the chin with moderate tension to prevent the helmet from being blown off, knocked off, or dislodged during movement.
 
Do not open ventilation holes on the helmet shell, as this weakens structural integrity. Inspect helmets regularly for cracks, dents, or wear; replace immediately if damaged, even after minor impacts. Avoid using snap-in style helmets without internal cushioning layers. Never remove, discard, or use helmets as seats. Store helmets away from direct sunlight and heat to prevent degradation. New helmets must carry valid production and product certificates, with intact shells, padding, and straps. Helmets are required indoors, especially during live electrical work, for both impact and insulation protection. Keep helmets clean, avoid graffiti, and replace lost or damaged units immediately. No one may enter the construction site without wearing a helmet.